Design Player

Use Design Player

to play through the stitches in the embroidery as if they were being stitched from an exported embroidery. All parts of the embroidery that are within the hoop area are shown, whether or not they are selected.

The current Optimize for Sewing settings from mySewnet™ Configure are used.

All the designs in a multipart embroidery are shown in the Design Player. This is therefore a good way to see the whole project after adjusting stitches in one of the designs.

Any messages, for example instructions for appliqué placement, are displayed following their Stop commands.
Appliqué fabric is displayed if present, but any background garment, quilt block or fabric is not shown.
Decorations are shown following their placement stitches.

Embroideries that are outside the hoop are not shown in the Design Player. If an embroidery contains a felting needle, the project will be shown "flipped", as it would actually be stitched.

Use Share

to save a picture or video of your design. See Share Picture and Share Video.

Shortcuts

Quick Access Toolbar; Home Tab:
Keys: Ctrl + J; Alt, 0; Alt, H, J

Using the Design Player

Click File, New

to open a new window.
In the Quick Access toolbar, click Insert

. See Insert.
Browse to Documents\mySewnet\Samples\Stitch Editor\Stitch\.
Scroll down to "Bumblebee 2 New".
Click to load the embroidery into the work area.
Click Design Player

.
The Design Player dialog opens.
Use the Play button

at the bottom left to start playing through the stitches in the embroidery.
Use the controls to play forwards or backwards through the embroidery at different speeds, jump to the start or end of the stitches, and stop at any time.