Use the Adjust Embroidery page to set the angle and position of the embroidery within the quilt block, and the margin around it.
This page appears after the Load Embroidery page if you chose Filled Quilt Block; Inner Embroidery in the Select Quilt Block Style page.
Note: If you loaded an embroidery that was too large for the specified quilt block, it is outlined in red. Return to the Select Size page and choose a different size for the quilt block, or select another embroidery.
Note: To reset all the settings quickly, go back to the Load Embroidery page and load the design again.
Position
-
Drag anywhere inside the solid blue line around the embroidery (the margin) to move the embroidery.
Note: If you drag the embroidery so that the margin is outside the edge of the quilt block, the outline becomes red, and the Continue button is dimmed (unavailable).
Angle
Use Angle to set the angle at which the embroidery is displayed from 0 to 359 degrees. The changes are shown in the preview.
Set the Angle for the Embroidery
-
Enter a number in the angle number box.
-
Click the arrows to increase or decrease the angle.
-
Drag the rotational slider to set the angle.
-
Click the Rotate 45 button
to rotate the embroidery by 45 degrees in a clockwise direction.
Mirror Horizontally
Use Mirror Horizontally
to mirror the embroidery from left to right.
Mirror Vertically
Use Mirror Vertically
to mirror the embroidery from top to bottom.
Margin
Use Margin to leave space between the embroidery and the fill around it.
Note: A blue line around the embroidery indicates the position of the margin. If the margin is outside the edge of the quilt block, the outline becomes red, and the Continue button is dimmed (unavailable).
-
Click the arrows to set the Margin from 0mm to 50mm.
Back
Return to the Load Embroidery page.
Continue
Go to the Select Fill Pattern page.