Load Design Wizard — Load Embroidery
This page is displayed if Load Sketch Embroidery was selected in the Design Options page.
Use the Load Embroidery page to load a .vp4 embroidery, with its hoop and background picture.
After choosing an embroidery, you can select a different embroidery but only the most recently chosen embroidery will be shown on the preview area.
It is not possible to drag and drop an embroidery onto the Load Design Wizard from Windows® Explorer.
Click Open Embroidery
to load an embroidery with the Open dialog box. Select the desired embroidery and click Open. The Open dialog box will close and the embroidery is shown in the preview area.
Click Paste
to load the embroidery shown in the Clipboard Block. The embroidery is shown in the preview area.
Paste is not available if the Clipboard Block is empty.
This shows the embroidery, if any, that has been copied or cut to the clipboard, either from another mySewnet™ Embroidery Software module or from within mySewnet™ Sketch before the Load Design Wizard was started.
Use Zoom In
to magnify the view of the embroidery. Move the pointer over the embroidery and the pointer changes to the zoom in pointer
. Then either click a point on the embroidery you want to zoom in towards, or click and drag a rectangle around the area you want to zoom in to and release the mouse button to zoom. When zoomed in, use the scroll bars to move around the embroidery.
Use Zoom Out
to shrink the view of the embroidery. Move the pointer over the embroidery and the pointer changes to the zoom out pointer
. Then click a point on the embroidery you want to zoom out from.
Click Zoom To Fit
to fit the embroidery to the preview area.
to view the embroidery at a magnification as close as possible to the Real Size setting you chose in mySewnet™ Configure.
Back
Return to the Design Options page of the Load Design Wizard.
Finish
Close the Load Design Wizard and show the embroidery on the work area.