Use Half Height Cross 
to place small crosses that occupy the upper or lower half of a grid square 
, and erase the upper or lower half of grid squares. Use single-click to place or erase one at a time, or drag draw continuously. A half height cross is placed in the side of a grid square nearest to the point where you click.
Two half height crosses can be placed in each grid square. It is not possible to place or erase part of a half height cross. If part of a half height cross is replaced or erased, the other half becomes a mini cross.
It is recommended to use a minimum Cross Size of 1.6mm for the design when using Half Height Crosses. Use Design Properties to set the Cross Size used by the design.
To Place a Half Height Cross
-
Select Half Height Cross
in the Create window 
, then click or drag on the work area to draw or replace crosses.
Note: Select Erase 
or press the Option key when drawing to erase crosses.