Use Transform to open the Transform dialog, where you can show and change the size, rotation and skew of the selected block.
In the Design Tab of the Design Panel
, click Transform
.
Select the block of objects, then choose Objects > Transform.
Use the Transform dialog to show and change the size, rotation and skew of the currently selected block.
Use Undo to reverse your changes.
Show and change the height and width
, or height
and width
percentage of the selected block.
Use this option to keep the relative Height and Width in proportion when either is changed.
Enter an angle , from 0 to 359 degrees, in the Angle box. The preview shows the selected angle.
Note: If desired, move the center of rotation before rotating.
In the Insert tab of the Design Panel
click to open the Design Gallery
.
In the viewer, scroll to the Flowers and Leaves Category, and select a flower design.
Click Insert to load the flower design.
Click Close to close the Design Gallery.
In the toolbar, ensure that Object Select is active and that the flower is selected.
Open the Design Tab of the Design Panel
.
Click Transform . The Transform dialog appears.
In the Size section, ensure that Proportional is selected (locked).
Change the Height percentage to 75%. The Width percentage will decrease by the same amount.
Click anothe text box to change the focus. In the background the flower changes in size.
In Rotate, click and hold on the up arrow. The flower rotates.
Change the width and height percentage Skew to reshape the flower design.
Click Close. The flower is using your new settings.
Click outside the select box to deselect the flower drawing.