"Another application is sending to a machine. Please try again later."
This message will appear if you attempt to send an embroidery when another mySewnet™ Embroidery Software module is already part way through sending an embroidery to the same card or machine. Wait until the first module has finished writing and then try again.
"Problem sending to machine."
This message will appear if any part of the Send system is missing or corrupt. Shut down your computer. Then start it and try again. If the message appears again, you may need to reinstall the mySewnet™ Embroidery Software.
"No stitches to send."
This message will appear if you attempt to send an embroidery, but there is no embroidery loaded so no stitches can be sent. Load the desired embroidery and try again.
"Communication has not been established with the machine. Ensure that the machine is switched on, and the cable is connected between the computer and machine, then click OK."
This message appears if the embroidery machine is not connected correctly to a USB port of your computer when you select the Send To function. The error message will appear after trying to connect for 2 seconds. Plug in or turn on the embroidery machine, then click OK.
"Cannot send design. Send currently in progress."
This message will appear if you attempt to send an embroidery when another mySewnet™ Embroidery Software module is already part way through sending an embroidery to the same machine. Wait until the first module has finished writing and then try again.
"There was an error transferring the file to the machine."
This message may appear if there is a communication error while sending an embroidery. Check the cable connections and the settings in mySewnet™ Configure. Ensure the mySewnet™ Machine module is started and try again.
"The design can only be saved and stitched out if it is rotated 90 degrees. Is that OK?"
This message will appear if the embroidery you are attempting to load is more than 200mm wide, but would fit if it was rotated; that is it is between 200mm and 360mm wide, and less than 200mm high. Click Yes to continue.
"Windows System Error. Please close and restart all software."
This message appears if there are issues with the memory handling of your system that make communication with your embroidery machine temporarily unavailable. Close and restart all programs running and try again. If this does not solve the issue, restart your computer.