Compensation

All stitches have a tendency to pull in. The pull varies according to fabric weight and type. Compensation is used to make a whole design or areas within it 'bolder' by increasing their relative size. The higher the number, the bolder the areas appear. You can also alter compensation for any individual area of satin or fill.

Note: Compensation does not apply to feathered satin, satin line, or any fill other than pattern fill.

You can set compensation from 0 to 30 for satin and 0 to 20 for fill areas. The setting for any Satin Column Continuous_Satin_icon03140.jpg, Satin Area Satin_Area_icon_m03142.jpg and Pattern Fill Pattern_Fill_icon_lg_dp03144.jpg area in the design is shown in the Area Properties for that satin or fill.

Compensation_on_Satin.jpg 

 

Compensation_on_Fill.jpg 

Satin Compensation

Pattern Fill Compensation

Note: Embroidery on thicker fabrics usually looks better with higher compensation, while on thin materials such as satin or twill a lower value or zero setting is usually more appropriate. As you create a design, use overlaps to prevent pulling from creating gaps between blocks of stitches that have different stitch directions. This provides 'built-in' compensation.

Density

Stitch Length

Satin Line Width

Fill and Satin Patterns

Gap and Shape

Start, End and Origin

Motif

Underlay

Feathered Side

Alignment Stitch Type