Satin Line is a line of constant-width satin stitch. It can be used alone, or as a border. The width of the line can be set from 1 to 12mm.
Width
Set Width for the satin line from 1 to 12mm. The initial setting is 4mm.
Density
Set Density from 2 to 15. The lower the number, the closer together the stitches and the more stitches are produced. The initial setting is 4.
Note: Embroidery on thicker fabrics usually looks better with more stitch coverage (a low density setting). Choose a low value such as 2 or 3 for heavy knit fabrics, and a higher value such as 5 or 6 for a light material like linen or satin.
Underlay
Use this option to place edge walk underlay inside each edge of the satin line.
Note: Underlay is not generated if the Width is set below 2mm.
Tapered Ends
The Start Point and End Point settings can be used to taper the ends of your satin lines.
Note: Use these options to create mitered or pointed ends for your satin lines.
Start Point
Use these options to change the type of line beginning for the satin line. Select a taper type, then set the Taper Angle
.
End Point
Use these options to change the type of line end for the satin line. Select a taper type, then set the Taper Angle
.
